Tag Archives: k+dcan

BMW ISTA

How to connect and set the BMW INPA K+DCAN USB interface for BMW ISTA Rheingold?

Posted on by SmartBimmer

How to connect and set the BMW INPA K+DCAN USB interface for BMW ISTA Rheingold? This is to connect the INPA cable with BMW ISTA. There is no problem with the test in this guide, but it will not be responsible for any potential loss or damage. Request for BMW Remote Support

Continue reading →
Uncategorized

BMW Standard Tools Installation Guide

Posted on by SmartBimmer

BMW Standard Tools Installation Guide This description is how we install and configure BMW Standard Tools, the suite of BMW software that includes INPA, NCS Expert, WinKFP, and Tool32. This setup is for E46 only. What is needed? What are the steps? The following posts cover each step for Windows 10. Other Windows versions may […]

Continue reading →
Uncategorized

How to Configuration and Verification the Interface with ISTA+?

Posted on by SmartBimmer

ISTA+: How to Configuration and Verification the Interface with ISTA+? The following information is freely available on the internet, however, has been consolidated here tohelp the DIYer in interface configuration (Rheingold, ISTA-D, and ISTA+ are all simultaneous and are used interchangeably. For the purposes of this document, we will only use 3 interfaces, K+DCAN,ENET and […]

Continue reading →