Tag Archives: bmw ista+

BMW Diagnostic Tool, BMW ISTA

How to solve BMW F32 Programming Problem with BMW ISTA-P?

Posted on by SmartBimmer

How to solve BMW F32 Programming Problem with BMW ISTA-P? When programming BMW F32 by BMW ICOM NEXT A, always got an error reading “Vehicle programming with ISTA-P is no longer approved for the connected vehicle. Vehicle management is now only possible with ISTA4. Please observe the release notes!” Solution: For BMW F/I/G series programming, […]

Continue reading →
Uncategorized

How to verify and configure your interface with BMW ISTA+?

Posted on by SmartBimmer

The following information is freely available on the internet, however, has been consolidated here tohelp the DIYer in interface configuration (Rheingold, ISTA-D, and ISTA+ all are simultaneous and are used interchangeably. For the purposes of this document, we will only use 3 interfaces, K+DCAN,ENET and ICOM. Additional configuration of these interfaces is not discussed here. […]

Continue reading →
Uncategorized

BMW ISTA+: set up for BMW F/I/G Series Programming

Posted on by SmartBimmer

How to set up BMW F/I/G Series Programming in it? Problem: I had an error when programming BMW F32 in ISTA-P 4.19.13 Expert Mode. Error: Vehicle programming with ISTA-P is no longer approved for the connected vehicle. Vehicle management is now only possible with ISTA 4. The version before ISTA 4 was called ISTA-D(aka Rheingold). […]

Continue reading →