Tag Archives: ista+

BMW Diagnostic Tool, BMW ISTA

How to solve BMW F32 Programming Problem with BMW ISTA-P?

Posted on by SmartBimmer

How to solve BMW F32 Programming Problem with BMW ISTA-P? When programming BMW F32 by BMW ICOM NEXT A, always got an error reading “Vehicle programming with ISTA-P is no longer approved for the connected vehicle. Vehicle management is now only possible with ISTA4. Please observe the release notes!” Solution: For BMW F/I/G series programming, […]

Continue reading →
BMW ISTA

BMW ISTA Programming P3.68 4.31 Release Notes

Posted on by SmartBimmer

BMW ISTA Programming P3.68 4.31 Release Notes 1 General notes（BMW ISTA need BMW ICOM NEXT connect to car）With the launch of ISTA 4, the functionality for programming has been integrated into ISTA. The following series can be dealt with using ISTA/P: 2 Overview of the I levels containedI level newly added or updated in this […]

Continue reading →
BMW ISTA

New Content: BMW ISTA V4.29.21 – Repair Instructions

Posted on by SmartBimmer

New Content: BMW ISTA V4.29.21 – Repair Instructions BMW ISTA needs BMW ICOM NEXT to connect BMW car Repair instructionsThe new publication has essentially been supplemented by the following Repair Instructions: The messages regarding the repair instructions, technical data, tightening torque, and operating supplies via the diagnosis system were taken into consideration and additions were […]

Continue reading →
BMW ISTA

BMW ISTA P Programming and Coding

Posted on by SmartBimmer

BMW ISTA P Programming and Coding BMW ISTA P stands for Integrated Service Technical Application Programming. It is a dealer-level diagnostic software that replaced the older version of SSS Program programming software. ISTA/P is primarily used for processing all coded, programmed, and enable-dependent control modules of BMW vehicles. With the use of a K+DCAN or […]

Continue reading →
Uncategorized

How to Configuration and Verification the Interface with ISTA+?

Posted on by SmartBimmer

ISTA+: How to Configuration and Verification the Interface with ISTA+? The following information is freely available on the internet, however, has been consolidated here tohelp the DIYer in interface configuration (Rheingold, ISTA-D, and ISTA+ are all simultaneous and are used interchangeably. For the purposes of this document, we will only use 3 interfaces, K+DCAN,ENET and […]

Continue reading →
Uncategorized

BMW ISTA+: set up for BMW F/I/G Series Programming

Posted on by SmartBimmer

How to set up BMW F/I/G Series Programming in it? Problem: I had an error when programming BMW F32 in ISTA-P 4.19.13 Expert Mode. Error: Vehicle programming with ISTA-P is no longer approved for the connected vehicle. Vehicle management is now only possible with ISTA 4. The version before ISTA 4 was called ISTA-D(aka Rheingold). […]

Continue reading →