BMW ISTA

Configure BMW ISTA 4.28.xx Software with New Firmware

Posted on by SmartBimmer

Configure BMW ISTA 4.28.xx software with new Firmware

What is BMW Rheingold ISTA ?

BMW ISTA is a workshop system that contains BMW AG Data and Information. ISTA stands for Integrated Service Technical Application. Way back when, during the initial development of this tool, BMW used DIS (Diagnostics Information System), and as the programs evolved and due to the nature of the file naming conventions utilized by BMW, the workshop system became known as Rheingold in the enthusiast world. Rheingold in actuality is the folder that contains the main application and data. Rheingold became ISTA-D (D stands for Diagnostics) and BMW’s programming application (not discussed in this document) used the same nomenclature, ISTA except with a P (for programming) or ISTA-P.Configure BMW ISTA 4.28.xx software with new Firmware

This instruction shows you a guide on how to configure BMW ISTA 4.28.xx software with new Firmware BMW_ISPI_ICOM-FW_03-15-04.msi for ICOM A1 & A2.

Requires:

BMW Rheingold ISTA+ 4.31.40 4.23.14 &ISTA-P Free download

Config Manual for ISTA 4.28.xx & BMW Standard tools

  1. ICOM A1, A2, BMW ICOM update firmware to BMW_ISPI_ICOM-FW_03-15-04.msi
  2. Log into ICOM http://169.254.92.38:58000/Configure BMW ISTA 4.28.xx software with new Firmware
  3. Go to LAN Setting and set Discover Mode to APIPA Save Changes and reboot ICOM.Configure BMW ISTA 4.28.xx software with new Firmware
  4. On your Laptop go to Ethernet Properties and set (TCP/IPv4) to DHCP. Connect your laptop and ICOM with an Ethernet cable.Configure BMW ISTA 4.28.xx software with new Firmware
  5. Open Ediabas konfigurator2.0.0; Select ICOM (Ethernet) This will be used with ISTA 4.28.x.x For BMW Standard Tools check the setting below. Under BMW Standard Tools Config, Configure BMW ISTA 4.28.xx software with new FirmwareClick on OK
  6. Open ISTA 4.28.xx and set Vehicle Interface to see below.Configure BMW ISTA 4.28.xx software with new FirmwareConfigure BMW ISTA 4.28.xx software with new Firmware
  7. You Can now connect to your car E – F – G series. See that your ip has changed to 192.168.x.x This will not be happening with INPA……

BMW Standard Tools Config

After you have configured everything for ISTA 4.28.xx and everything works as described above. You only need to set the (Configuration) Interface = to Remote as indicated below. EDIABAS will connect with IP 169.254.92.38Configure BMW ISTA 4.28.xx software with new Firmware

This will be used for BMW Standard Tools

You can now connect with ITool Radar or Easy Connect, and use INPA, NCS-Expert Tool, Tool32, and WinKFP.

SmartBimmer